Kera by Laura Aylor

Kera

Knitting
March 2017
DK (11 wpi) ?
20 stitches and 26 rows = 4 inches
in blocked stockinette
US 6 - 4.0 mm
1000 - 1800 yards (914 - 1646 m)
to fit bust measurement 30, (33, 36, 39, 42), {45, 48, 51, 54}. See schematic for actual garment measurements
English
This pattern is available for $7.00 USD buy it now

Spend $25 or more in my Ravelry shop in one transaction and you will automatically receive 25% off your entire purchase!

This deceptively simple pullover is knit from the bottom up and features seamless saddle-shoulder shaping for a clean fit. Kera is graphic, yet understated; decrease lines define the shoulders, and slashes of a contrasting color mark the pockets. With flattering waist shaping concentrated in the back, Kera is an easygoing sweater that doesn’t sacrifice silhouette.

Sized with 5% positive ease at the bust, but choose your size based on your cross-back measurement. As long as your bust measurement is within an inch or two on either side of the bust measurement that corresponds to your cross-back, you should not need to make alternations. (Cross-back is measured across the back from where “seam” hits to the same spot on the other side – the red line in the schematic.)

Note: Shown modeled by my daughter with just a bit more ease than actually recommended.

The pattern has been tagged as seamless, although the pocket linings are stitched down. The overall construction method, however, is seamless.

Skills required:
• Long-tail cast-on
• Knitting in the round
• Increasing
• Decreasing
• 3-needle bind-off
Icelandic bind-off

Yardage details (main sweater yarn, excluding lining):
• 30” - 1000
• 33” - 1100
• 36” - 1200
• 39” - 1300
• 42” - 1400
• 45” - 1500
• 48” - 1600
• 51” - 1700
• 54” - 1800

Materials:
• Light worsted/DK weight yarn for your size (see above for amounts). Sample was knit in Miss Babs Yowza (superwash merino wool)
• 50-75 yards of lighter-weight yarn for the pocket lining. Sport-weight is a good choice
• US 6/4 mm needles, or size needed to obtain gauge in stockinette – you will need needles for working the sleeves and body in the round
• US 5/3.75 mm needles, or size needed to obtain gauge in garter – you will need needles for working the sleeve cuffs and the neck in the round, as well as for working the body hems flat
• Stitch markers, including two locking markers
• Tape measure
• Waste yarn for holding pocket stitches and sleeves
• Tapestry needle

Pattern chat thread is here. Join us and discuss yarn options, share your progress, get help, and show us your finished sweaters!

Sample knit in Miss Babs Yowza in Lycan and madelinetosh 80/10/10 Sport in Celadon.